Metrology Technician - Dimensional - ClearanceJobs : Job Details

This Technician is responsible for providing calibration and repair services on Dimensional/Gage Block equipment in the Physical/Mechanical Laboratory. Applies advanced technical knowledge to solve complex problems that typically cannot be solved solely by referencing manufacturer's manuals or similar documents. Requires the ability to use complex test instruments and control equipment.

Requirements, Experience, and Education:

• Associate's Degree, or related equivalent experience desired.
• Minimum equivalent experience is three (3) years' experience in metrology and repair of TMDE desired.
• Good working knowledge of calibration and maintenance of Dimensional/Gage Block primary measurements standards is a plus.
• Ability to read and understand schematic and wiring drawings.
• Thorough understanding of the requirements of ISO/IEC 17025 and USAF T.O. 00-20-14 is a plus.
• Must be a U.S. Citizen.
• Must be able to qualify for or have successfully completed a National Agency Check Investigation within the last ten (10) years.
• Above average proficiency with Microsoft Office (Outlook, Excel, Word), Windows based operating systems, and general internet navigation and usage required.

Responsibilities and Duties: Essential/Typical Duties:

• Maintains, repairs, and calibrates Dimensional/Gage Block Test, Measurement and Diagnostic Equipment (TMDE).
• Performs general maintenance and overhaul procedures; uses TMDE to troubleshoot and repair equipment.

Non-Essential Duties:

• Performs other related duties as assigned.

Physical Requirements: Often - Climbing, Stooping, Kneeling, Reaching, Standing, Sitting, Walking, Pushing, Pulling, Talking, Hearing

Lifting/Moving Requirements: The individual ability to lift up to 50 pounds and the ability to perform repetitive hand and arm movements when calibrating certain TMDE.

Environmental Conditions: Normally works in an environmentally controlled work area.